Vehicles utilizing the vehicle status monitor feature:
The vehicle status monitor feature alerts you of engine oil replacement by turning on the wrench indicator light or displaying a message in the instrument panel, or both.
Every engine oil replacement must be done when the display/wrench indication comes on. The display/wrench indication will come on before reaching the maximum interval of 16,000 km (10,000 miles), or 12 months (after the previous maintenance).
If you are following 8,000 km (5,000 miles) or 6 months maintenance interval, set the vehicle status monitor manually.
Refer to the owner's manual section of mazda.ca for the Mazda Connect owner's manual or contact an Authorized Mazda Dealer if necessary.
Canada residents
Maintenance Interval |
Number of months or kilometers (miles), whichever comes first. |
||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Months |
6 |
12 |
18 |
24 |
30 |
36 |
42 |
48 |
54 |
60 |
66 |
72 |
|
×1000 km |
8 |
16 |
24 |
32 |
40 |
48 |
56 |
64 |
72 |
80 |
88 |
96 |
|
×1000 miles |
5 |
10 |
15 |
20 |
25 |
30 |
35 |
40 |
45 |
50 |
55 |
60 |
|
Engine oil & filter*1*2 |
Replace when the wrench indicator light is ON. (Upper limit interval is 16,000 km (10,000 miles) or 12 months.) |
||||||||||||
Spark plugs |
SKYACTIV-G 2.5T |
Replace every 64,000 km (40,000 miles). |
|||||||||||
Except SKYACTIV-G 2.5T |
Replace every 120,000 km (75,000 miles). |
||||||||||||
Air filter |
Replace every 56,000 km (35,000 miles) or 36 months. |
||||||||||||
Drive belts*3 |
I |
I |
|||||||||||
Engine coolant level |
I |
I |
I |
I |
I |
I |
I |
I |
I |
I |
I |
I |
|
Engine coolant*4 |
Replace at first 192,000 km (120,000 miles) or 120 months; after that, every 96,000 km (60,000 miles) or 60 months. |
||||||||||||
Fuel lines & hoses*5 |
I |
I |
I |
||||||||||
Hoses and tubes for emission*5 |
I |
||||||||||||
Brake lines, hoses and connections |
I |
I |
I |
||||||||||
Vacuum brake booster and hose |
With vacuum booster |
I |
I |
I |
I |
I |
I |
||||||
Brake fluid |
With electrical booster |
R |
R |
R |
|||||||||
Disc brakes |
I |
C/L |
I |
I/C/L |
I |
C/L |
I |
I/C/L |
|||||
Tire rotation |
Rotate every 8,000 km (5,000 miles). |
||||||||||||
Tire inflation pressure and tire wear*6 |
I |
I |
I |
I |
I |
I |
I |
I |
I |
I |
I |
I |
|
Steering operation and linkages |
I |
I |
I |
||||||||||
Front and rear suspension, ball joints and wheel bearing axial play |
I |
I |
I |
||||||||||
Body condition inspection for rust, corrosion and perforation |
I |
I |
I |
I |
I |
I |
|||||||
Driveshaft dust boot |
I |
I |
I |
||||||||||
Bolts and nuts on chassis and body |
T |
T |
T |
||||||||||
Exhaust system and heat shields |
I |
||||||||||||
Cabin air filter |
Replace every 40,000 km (25,000 miles) or 24 months. |
||||||||||||
Chart symbols:
I: Inspect: Inspect and clean, repair, adjust, fill up, or replace if necessary.
R: Replace
C: Clean
L: Lubricate
T: Tighten
Remarks:
Reset the engine oil data whenever replacing the engine oil regardless of the message/wrench indicator light display.
If you drive your vehicle under any of the following conditions, replace the engine oil & filter every 8,000 km (5,000 miles) or 6 months, whichever comes first.
The vehicle is idled for long periods or driven at low speeds, such as with police cars, taxis, or driver's education school vehicles.
Driving under dusty conditions.
Driving for long periods in cold temperatures or driving regularly for short distances only.
Driving under extremely high temperature conditions.
Driving continuously in mountainous regions.
Also inspect the air conditioner drive belts, if equipped.
If the vehicle is operated primarily under any of the following conditions, inspect the drive belts more often than the recommended intervals.
Driving under dusty conditions.
The vehicle is idled for long periods or driven at low speeds.
Driving for long periods in cold temperatures or driving regularly for short distances only.
Driving under extremely high temperature conditions.
Driving continuously in mountainous regions.
Driving for long period in extremely wet or heavy rain condition.
Use of FL-22 is recommended when replacing engine coolant. Using engine coolant other than FL-22 may cause serious damage to the engine and cooling system.
According to state/provincial and federal regulations, failure to perform maintenance on these items will not void your emissions warranties. However, Mazda recommends that all maintenance services be performed at the recommended time or mileage/kilometer period to ensure long-term reliability.
Inspect a spare tire if equipped.
Page top